Hi everyone,

I understand that, using the special cable ( A-100 BC ), you can connect TWO bus boards together. Without using e.g. A-185, is it possible to connect ALL THREE BUS boards within a single P9, such that the CV / Gate control from my A-190-2 will be available across the entire system

I think it's most likely that my A-110's and A-140's will occupy the lower and middle BUSses, but should I wish to expand onto the upper BUS, is there a way to get the CV / Gate control onto the upper BUS

Or, I suppose, turning the question on it's head, is it always a good idea to limit BUS-aware modules to a single BUS, with a link to a second BUS being the clear exception rather than the rule.

Either way, is there a practical ( safe ) limit to the number of modules that can be 'driven' by the A-190-2

Best wishes,

Nick,
Cardiff, UK.