Hi Ricardo / Dieter


Am 23.10.2012 16:36, schrieb yahoo@... :

> I think he is right. The Meanwell PSU is obviously a single PSU (i.e. one
> voltage output only, not two like the A-100PSU2). In this case the -V output
> of the Meanwell has to be connected to GND of the A-100 system. You may use
> e.g. a free GND terminal at the bus board. The +V of the Meanwell (= +5V)
> has to be connected to the unused +5V terminal of the A-100 bus board.

Thank you for the correction!
I have a +/-15V supply from Meanwell and was transfering the connection
info from there.

I should have had a look at the datasheet before:
http://www.jameco.com/Jameco/Products/ProdDS/123290.pdf
At page 2 you can see that the 5Volts are between -V and +V.

Florian

--
http://fa.utfs.org/