They are floating outputs so it doesn't matter which goes to which. If using
a 4-pin connector then use 2 pins for each wire - the thicker the better.

Best Regards
Laurie Biddulph
Mobile: 0400 257 645
Web: www.elby-designs.com

-----Original Message-----
From: Doepfer_a100@yahoogroups.com [mailto: Doepfer_a100@yahoogroups.com ] On
Behalf Of istari
Sent: Tuesday, 15 November 2011 8:16 PM
To: Doepfer_a100@yahoogroups.com
Subject: 1 doepfer diy set 1

hi

befor i blow up anything.

am i right i just dont have to care which cabel from the external 15V
Transformer
goes to the diy powersupply board

the transformer got a red and a white stripe but the board just got
to pins for 15V AC.

i will put some xlr connection inbetween the case also.

best
felix



------------------------------------

Yahoo! Groups Links