Thanks Dieter
If i have to change those resistors (The three feedback resistors R4, R9 and R13 that i have to changed from 47k to 91k)
Which are the most recommended resistors that I can buy in small quantities and where if possible
Thanks again

Ric

--- In Doepfer_a100@yahoogroups.com , <yahoo@...> wrote:
>
> > Hi all! I want to buy A-176 voltage sources in order to DC
> > control some other modules, My question is ( excuse my lack of
> > knowledge):
> > Is it possible to change the" 0 to +5V" values in the A-176 to
> > "0 to +10V"
> > I read in the A-176 manual that there are some jumpers at the
> > back in order to change the values from 0 to +5V to -2.5 to
> > +2.5V But the modules I want to control take up to 10v.
> >
> > Any other solution (or modules to buy) so I can get the +10v dc
> > source that I need
> >
> > Thanks all in advance
> >
> > ric
>
> That's no problem. The three feedback resistors R4, R9 and R13 have to
> changed from 47k to 91k. These are the only 47k resistors on the A-176
> board.
>
> Best wishes
> Dieter Doepfer
>