Have a look on a Doepfer module with the faceplate showing towards you and looking on the top of the jack.You only have to connect the pins on the right hand side (as the left ones are used only when it´s a switching jack). The pin near the faceplate is the ground pin, the other one is the signal pin.

So just connect the signal pin of the module with the signal in of the jack. The same with ground. No idea how the Switchcraft jacks you want to use look like, so I can´t tell which pin is which. Do you have a number or a name of this jack Then I could look it up on the Switchcraft website and tell you the rest.

best,
Paul S. (No, I´m not Mr. Schreiber from Synthtech ;-)

----- Original Message -----
From: noisejazz
To: Doepfer_a100@yahoogroups.com
Sent: Wednesday, September 04, 2002 4:34 PM
Subject: 1 Daft Question


I am getting some schaffer panels made to modify my doepfer modules
to larger knobs and 1/4" jacks.
On the doepfer pcb's there are 4 holes where the onboard jacks fit.
If I am wiring these into Switchcraft jacks, which pins do I connect
to where. Sorry if this is a muppet question but I am really stuck.
Thanks in advance
Steve M.


Yahoo! Groups Sponsor
ADVERTISEMENT



To unsubscribe from this group, send an email to:
doepfer_a100-unsubscribe@yahoogroups.com



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



[Non-text portions of this message have been removed]