And are they all programmed to the same reference note Otherwise the transposition is different.

Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto: Doepfer_a100@yahoogroups.com ]Im Auftrag von RICHARD HORSMAN
> Gesendet: Donnerstag, 3. Juni 2010 18:20
> An: Doepfer_a100@yahoogroups.com
> Betreff: Re: 1 chained A-190-2's give strange results
>
>
> Are they all disconnected from the gate and CV bus
>
>
>
>
> ________________________________
> From: silvercreekvalley < silvercreekvalley@... >
> To: Doepfer_a100@yahoogroups.com
> Sent: Thursday, 3 June, 2010 17:01:49
> Subject: 1 chained A-190-2's give strange results
>
>
> I've got three A-190-2 (MIDI->CV converters) chained together so
> that the out from one goes to the 'in' on the other. I'm using
> the PCB pins for MIDI IN/OUT to do this as per the manual.
>
> I've set the key mode to 'stack', and set all the 190-2's so that
> they receive on midi channel 1.
>
> The three units all work, and as I press keys, the appropriate
> 190-2 triggers (ie the third unit triggers if 2 keys are already
> held down).
>
> However, while the pitch on the first unit is fine (its connected
> to a A110), on the second and third units the pitch is 2 or 3
> octaves lower. In fact its just clicks.
>
> Any ideas what I've done wrong For the three A110 modules, the
> range and tune settings are all identical.
>
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>