Hi Bakis:
 
Thanks for the advice.   Since I had bought this through eBay, I was careful with the any modules to make sure red strip was correct.  What I didn't check on some of the modules was if the strip was correct on the modules!  That was where the problem was on the a100.
 
Cheers,
 
Steve B

--- On Mon, 2/22/10, Bakis Sirros < synth_freak_2000@... > wrote:


From: Bakis Sirros < synth_freak_2000@... >
Subject: Re: 1 Another Newbie Question: Is my module dead
To: Doepfer_a100@yahoogroups.com
Date: Monday, February 22, 2010, 11:43 PM


 



are you sure you connected the A110 correctly to the busboard (redstripe down on the doepfer busboard) and is the module end of the ribbon connected correctly to the a100 pcb too (red stripe to the -12volts mark)

if yes, describe the patch you created in detail.

Bakis Sirros - Parallel Worlds / Interconnected / Memory Geist

1 group owner

www. parallel - worlds - music. com

www. myspace. com/ parallelworldsmusic

www. myspace. com/ interconnectedmusic

www. myspace. com/ memorygeist

www. DiN. org. uk

www. musicamaximamagneti ca. com

www. vu-us. com

www. shimarecords. co. uk

--- On Tue, 2/23/10, stevebdar <stevebdar@yahoo. com> wrote:

From: stevebdar <stevebdar@yahoo. com>
Subject: 1 Another Newbie Question: Is my module dead
To: Doepfer_a100@ yahoogroups. com
Date: Tuesday, February 23, 2010, 4:40 AM

 

I installed all the Doepfer modules in my new case, along with my 2 Livewire modules. Everything seems to work properly except when I try to use my VCO A110. If I add a plug to it, all the lights on the other modules turn off.

Does this mean the module is dead

Thanks

Steve B

[Non-text portions of this message have been removed]











[Non-text portions of this message have been removed]