Hi Bakis:
 
Would the same apply to an ASys RS50 and RS60
 
 
Thanks
 
 
Steve B

--- On Sat, 2/13/10, Bakis Sirros < synth_freak_2000@... > wrote:


From: Bakis Sirros < synth_freak_2000@... >
Subject: Re: 1 Newbie Question: Adding a Plan B M17 to a Doepfer 9U Case
To: Doepfer_a100@yahoogroups.com
Date: Saturday, February 13, 2010, 2:57 AM


 



hi Steve,

Plan B modules use the standard doepfer type ribbon power cable.

just make sure that the red stripe goes to -12volts on both the busboard and on the module PCB ends.

thanks,
Bakis.

Bakis Sirros - Parallel Worlds / Interconnected / Memory Geist

1 group owner

www. parallel - worlds - music. com

www. myspace. com/ parallelworldsmusic

www. myspace. com/ interconnectedmusic

www. myspace. com/ memorygeist

www. DiN. org. uk

www. musicamaximamagneti ca. com

www. vu-us. com

www. shimarecords. co. uk

--- On Sat, 2/13/10, stevebdar <stevebdar@yahoo. com> wrote:

From: stevebdar <stevebdar@yahoo. com>
Subject: 1 Newbie Question: Adding a Plan B M17 to a Doepfer 9U Case
To: Doepfer_a100@ yahoogroups. com
Date: Saturday, February 13, 2010, 6:46 AM

 

I've been buying modules (always looking) for my new modular set-up which will be housed in a Doepfer a-100lc9 9U case.

My question is about adding a Plan 9 M17 to this case. Will it connect to the bus like a standard Doepfer module or will I need a special ribbon cable and connector

Thanks

Steve B

[Non-text portions of this message have been removed]











[Non-text portions of this message have been removed]