> Hello list!
>
> I'm thinking about moving my basic set worth of A-100 modules to a 9U
> low-cost case, but some questions came up. I would greatly appreciate some
> help from you on these points:
>
> (1) I currently own a standard system 2---that is the version
> with an A-190
> MIDI to CV module. I got this system in late 2003 or early 2004.
> Now does my
> set have an A-100AD5 low-cost 5-volt adapter for the A-190 or maybe an
> A-100NT5 5-volt power supply I can't check this myself since I'm away at
> the moment. Hopefully it's the A-100AD5 since it would be a lot easier to
> transfer that to the new case.
>
> (2) I want to have a single CV/gate bus running through the whole 9U
> low-cost case. Are the three bus boards connected like this as a
> default If
> not, then I guess I need to get a couple of those special cables for this.
>
> Thanks already!
>
> Samuli

If you ordered a basic system 2 it's equipped with an A-100AD5 for the
A-190. The A-100AD5 is usually located next to the bus connector of the
A-190. The basic system 2 is usually also equipped with an internal bus
cable (i.e. the CV lines of both bus boards are connected by means of a
one-wire cable). These specs are valid only if a complete basic system 2 has
been ordered (not for custom made systems).

Best wishes
Dieter Doepfer