thanks, can anyone who has used both tell me how extreme the difference
is between the older and newer A-198 - it sounds from the description
as if the pressure sensor older one is not really easily playable

Richard



yahoo@... wrote:

>
>
>
> Please look at our FAQ page:
>
> www.doepfer.com > FAQ > R2M/A-198 > How can I distinguish between the old
> and new version of the manual
>
> Best wishes
> Dieter Doepfer
>
> > -----Ursprüngliche Nachricht-----
> > Von: Doepfer_a100@yahoogroups.com <mailto:Doepfer_a100%40yahoogroups.com>
> > [mailto: Doepfer_a100@yahoogroups.com
> <mailto:Doepfer_a100%40yahoogroups.com>]Im Auftrag von Richard Scott
> > Gesendet: Samstag, 16. Mai 2009 02:56
> > An: Doepfer_a100@yahoogroups.com <mailto:Doepfer_a100%40yahoogroups.com>
> > Betreff: 1 A-198 question
> >
> >
> > the description of this modules mentioned old and new versions But is
> > there any way to physically/visually distinguish these For the older
> > version it says:
> >
> > "the pressure sensor is made with conductive rubber located below the
> > position sensor and works not as accurate as the very precise position
> > sensor. The resistance of the conductive rubber changes with varying
> > pressure and causes a variable voltage. But the coherence between
> > pressure and resistance/voltage is not very accurate - except that an
> > increasing pressure will cause an increasing voltage. Even some
> > difference of the pressure sensor behaviour over the length of the
> > manual may be possible as the conductive rubber has tolerances over this
> > length."
> >
> > Richard
> >
> >
> > ------------------------------------
> >
> > Yahoo! Groups Links
> >
> >
> >
>
>