Hi Wolfgang
Can you please tell me how to test three voltages are ok -12V/+12V/+5V
on A-100P

thanks David

On 8/06/2008, at 10:22 AM, wolfgthiel wrote:

> Hi David
>
> Was the A-190 working before you did the reset
> Have you checked if all three voltages are ok -12V/+12V/+5V.
> I don't think there is a fuse in the A-190 modul (just had a look at
> my
> one)and I'm not familiar with the Doepfer power supply. In general you
> could take the fuse out and replace it with a new one of the same
> rating, or if you familiar with a multimeter take the fuse out and
> check continuity of the fuse with an ohm meter.
> Good luck.
>
> Wolfgang
>
> --- In Doepfer_a100@yahoogroups.com , David Bulog <d2ba@...> wrote:
> >
> > I went do a full reset of the A-190 by powerup while holding buttons
> > 1-4 on power up
> > When I powered the unit on the lights on the A-190 came on
> momentarily
> > and then no power.
> > Has anyone had a similar issue
> >
> > BTW -How do I check if fuse is vlown
> >
> > thanks David
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>



[Non-text portions of this message have been removed]