--- In Doepfer_a100@yahoogroups.com , "thomasborax" <thomasborax@...>
wrote:

>
>
> >
> > My first idea: the internal connection is broken. It's a blank wire
> that
> > connects the solder point "JP4" of all four boards, located behind
> the mix
> > polarizer potentiometer at the pcb edge. But I'd wonder why this
> should
> > break if the module is connected to Peter Grenader's model 13 :-)
> >
> >
>
>
> i had a similar problem with my 143-2. the normalizing gates didn't
> normalize to env # 1. the blank wire that went through all four
> circuit boards appeared ok, but further scrutiny revealed that it had
> some "wiggle" to it. it needed to be soldered again, though the wire
> itself was not broken at all, just too loose to have a good
> connection at the joints.
>
> as soon as i re-melted the solder that was already there it worked
> perfectly.
>
> -t
>

Thanks for the advice:)

I check things out tomorrow at work.


Cheers,
thglyph