Hi bakis,

no, thats not the problem. it also behaves like that when nothing is
pluged in.
thanks for the hint.
helitron


--- In Doepfer_a100@yahoogroups.com , Bakis Sirros
<synth_freak_2000@...> wrote:

>
> just an idea...
> i had one malfunctioning adsr, in one of my a143-2,
> for a few minutes, until i found out that the tip of
> the minijack plug (when it was plugged in of
> course)was touching the pins of the led that is right
> behind the respective 'adsr out' minijack socket, of
> the said adsr. i just bended the pins a bit and
> everything was fine!
>
>
> --- helitr0n <helitron@...> wrote:
>
> > Hi Florian,
> >
> > thanks for the hint. you mean JP5 that looks
> > properly soldered, like
> > all other solderjoints on the board.
> > and retriggering via LFO while holding down the
> > gate, does retrigger.
> > however it depends on the sustain/decay pot
> > settings. if both are low
> > the EG goes low when the retrigger signal goes high.
> > if decay/sustain
> > are high (>3) then it retriggers.
> > however the overal env voltage seems low since the
> > LED is quite dimm.
> >
> > hel
> >
> > --- In Doepfer_a100@yahoogroups.com , Florian
> > Anwander
> > <Florian.Anwander@> wrote:
> > >
> > > Hi helitr0n
> > >
> > >
> > > > one of the four EGs is not working properly:
> > > > when the sustain = 0, the output is high,
> > without beeing triggered.
> > > > however, when a trigger/gate is applied, the
> > envelope stops for the
> > > > duration of the signal, and then it goes high
> > again.
> > > > with sustain >3, the envelopetriggering behaves
> > normally, but the
> > > > output is too low compared to the other EGs on
> > the module.
> > > > additionally, decay and relese also affect the
> > triggering behaviour.
> > > I had a look at the schematics: this sounds like
> > the wire bridge "J10"
> > > has been forgotten or is not solder correctly: it
> > is close to the Decay
> > > potentiometer and the IC1 (a 555).
> > >
> > > How does the Envelope react on a slow rectangle
> > LFO at retrigger in
> > > while the gate is high (key pressed).
> > >
> > > Florian
> > >
> >
> >
> >
>