yes thats right, this was the problem.
but the solution is also as easy as mr. doepfer said :)

thx




Chris Henkel schrieb:

>
> ...I think the problem is that the cable is diconnected from the
> _module_ -
> so there is no way of checking which one is connected to the module...
>
> 2008/3/5, hardware@... <mailto:hardware%40doepfer.de>
> < hardware@... <mailto:hardware%40doepfer.de>>:
> >
> > If there is a 16 pin bus connector on a module you need a 16 pin cable
> > If there is a 10 pin bus connector on a module you need a 10 pin cable
> >
> >
>
> [Non-text portions of this message have been removed]
>
>

[Non-text portions of this message have been removed]