> i just fixed the problem by calibrating the maq, this is a very nice
> procedure.
> i couldnt get the 36 (lowest setting of the knob) to G#3, it was just
> not possible to reach
> by the trim pot of the maq and the tune fader of the synth.
> so i set 36 to A#2.

That's because of the DC offset of the CV outputs (see page 7 of the user's
manual). The MAQ16/3 has been developed more than 10 years ago and it was a
problem to find an affordable triple DA converter at this time. For new
designs such DC offsets are avoided.

Best wishes
Dieter Doepfer