as the problem occurs with 2 different synthesizers in the same way, i
really think that my maq is detuned.
but before i open it for calibration i will test it with my new a100
system just to be sure its the maqs fault.
as i understand the manual there is no danger in doing this procedure
im somewhat affraid to open the device and fiddle with a screwdriver
while its running ...



hardware@... schrieb:

>> hello group
>>
>>
>> i realized that my maq 16 has a detuned cv output, while midi part is in
>> perfect tune.
>> when i connect a synth with cv / gate and play a middle c on the maq
>> i tune the synth to c
>> now i play a higher c on the maq and its not in tune anymore (slightly
>> lower then it should be)
>> when i play a lower note then the middle c it gets out of tune in the
>> other direction (higher then it should be)
>> i tested it with 2 different synths with this result, and i also tested
>> the synths itself with their own keyboards,
>> there it works just fine.
>> could this be a calibration problem of the maq16
>>
>
> The calibration of the CV outputs is described in the MAQ16/3 manual on page
> 31 (appendix E).
>
> Best wishes
> Dieter Doepfer
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>

[Non-text portions of this message have been removed]