--- In Doepfer_a100@yahoogroups.com , "ilanode" <techmeier@...> wrote:

>
> If hooked up correctly: No. Only diff. is that those modules are no
> longer connected to the gate and cv signals on the bus board.
>
> --- In Doepfer_a100@yahoogroups.com , "jeswa" <j@...> wrote:
> >
> > The Analogue Haven description for the 16 pin to 16 pin cable reads:
> >
> > "Make sure that the module in question uses all 16-pins on the PCB
> > side (such as the A-110, A-111, A-140, A-142 and others)"
> >
> > Is there any harm in using these cables with a 10 pin bus

connector,

> > assuming it's hooked up corectly

Right, no harm, it was an attempt to distinguish the two cables on our
webpage. Maybe I will edit the text when I find some time.

Shawn Cleary
www.analoguehaven.com