Dieter says:
"Dear members,

I designed a crossfader module based on Florian's
suggestions. Here is the
link for the preliminary info:

www.doepfer.de/a138d.htm

It is only a preliminary version and should be treated
as as basis for
discussions. From my point of view there are three
possible ways:

1. A complete module similar to the suggested A-138d

2. An expansion module that has to be connected to an
existing A-138 (a or
b). This would be a little bit cheaper as the
electronics of the A-138 can
be used (but not much as the electromechanical parts
remain the same and the
electronics is not very expensive). For this solution
the single outputs
would not be available and a little bit of soldering
is necessary (2 wires
have to be soldered to the A-138). I don't think that
this solution is
meaningful.

3. same as 2. but only as a DIY project. It's very
simple. Most of the work
will be the front panel processing. The "electronics"
is only a few
resistors some potentiometers. I can publish the
schematics on the A-100 DIY
page.

Bakis, maybe a poll will be helpful (thank you in
advance ... :-). And of
course ideas/improvements of the suggested A-138d.

Best wishes
Dieter Doepfer"






Bakis Sirros - Parallel Worlds
1 group owner
http://www.parallel-worlds-music.com
http://www.myspace.com/parallelworldsmusic
http://www.shimarecords.co.uk
http://www.rubber.gr
Athens-Greece



____________________________________________________________________________________
Do you Yahoo!
Everyone is raving about the all-new Yahoo! Mail beta.
http://new.mail.yahoo.com