Enter your vote today! A new poll has been created for the
Doepfer_a100 group:

How would you like the forthcoming A138d crossfader module to be realized [for a suggested module sketch look here:
http://www.doepfer.de/a138d.htm ] regarding your options to choose from: 1. A complete module similar to the suggested A-138d

2. An expansion module that has to be connected to an existing A-138 (a or
b). This would be a little bit cheaper as the electronics of the A-138 can
be used (but not much as the electromechanical parts remain the same and the
electronics is not very expensive). For this solution the single outputs
would not be available and a little bit of soldering is necessary (2 wires
have to be soldered to the A-138). I don't think that this solution is
meaningful.

3. same as 2. but only as a DIY project. It's very simple. Most of the work
will be the front panel processing. The "electronics" is only a few
resistors some potentiometers. I can publish the schematics on the A-100 DIY
page.


o option 1.
o option 2.
o option 3.


To vote, please visit the following web page:
http://groups.yahoo.com/group/Doepfer_a100/surveys id=12471627

Note: Please do not reply to this message. Poll votes are
not collected via email. To vote, you must go to the Yahoo! Groups
web site listed above.

Thanks!