Hi kaalimus

> The last note mode sounds like it should be doing what i want it to
> do, but it does not. Maybe the correct mode would be a "first note
> priority", if there was such as mode.

No what you are looking for is a "lowest note, non-hold, last keypress"
algorithm.

There are a lot of possible algorithms for monophonic keyboards, which
affect different aspects of a key press.

Lowest/highest/new-note-priority decides which of two actually pressed
keys determines the CV

Hold/non-hold determines what happens to the CV if two keys are pressed
and if the one key is release, which determined the CV until the key
release.

Last/first-keypress-priority decides which of two key presses create a
gate or trigger signal.

Legato/Retrigger describe whether a new gate is given when the CV changes.


Florian

>
> --
> K
>
> --- In Doepfer_a100@yahoogroups.com , "Silas Johansen" <sijodk@...>
> wrote:
>
>>My A110's require the tuning knob to be in different positions for
>
> them to
>
>>be in tune. I assume this is normal.
>>
>>Your second question is answered on page 15 (Assign mode) of the
>
> A190
>
>>manual, available at http://www.doepfer.de/a100_man/A190_man.pdf
>>
>>Cheers,
>>
>>Silas
>>
>>On 11/16/06, kaalimus < v@... > wrote:
>>
>>> Hi,
>>>
>>>Two questions, both might have been anwered on this board already,
>>>but i couldn't find anything definite by searching.
>>>
>>>The first question is about tuning. I have two A-110 VCOs. What is
>>>the supposed neutral setting for the Tune knob, if there is one I
>>>have to tune it to a bit over 8, to get a proper tune. Tracking
>
> works
>
>>>fine.
>>>
>>>The second question, is there a way to set the A-190 MCVS to work
>>>like this: If i press C3 on my keyboard, keep it down and press C4
>>>simultaneously, then release C4 while holding the C3, and the
>
> synth
>
>>>should play C3 again. This is how my other synths work.
>>>
>>>Thanks.
>>>
>>>
>>>
>>
>>
>>[Non-text portions of this message have been removed]
>>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>

--
Florian Anwander, Consulting&Solutions Software GmbH
Franziskanerstr. 38, D-81669 Muenchen, Tel. ++49(89)45841-133
http://www.consol.de