All three LEDs stay on permanent. All the other modules are working fine off of that same bus board.

hardware@... wrote: William,

you find my answers below

> All, question on tha A-191.
>
> Prior to the installation of the A-191, I did plug into the
> Doepfer bus the A100-AD5
> 5V Low-Cost Adapter. I plugged it in correctly :-)!!!!
>
> Now, with the system powered up, and the A-191 plugged in
> correctly, should the lower 3 LEDs be on steady

It depends upon the operation mode. In the MCV mode they are all off. In the
Shepard mode the lowest LED has to be on permanently. For the other two LEDs
it depends if you have chosen the up, down or up/down mode.
Details how to enter the different modes are described in the user's manual.

> Manual refers to
> them as number 8 when describing the controls on the panel. Have
> not really tried the module yet. Will know more today.
>
> Everything else that is plugged into that bus, where the A-191
> is plugged, is working fine....and the bus is not over populated.
>
> Mahalo,
>
> William
> Hawaii
>
>
>
>
>
>
>
>
> ---------------------------------
> Get your email and more, right on the new Yahoo.com
>
> [Non-text portions of this message have been removed]
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
>

Yahoo! Groups Links













---------------------------------
Do you Yahoo!
Everyone is raving about the all-new Yahoo! Mail.

[Non-text portions of this message have been removed]