Hi,

A few months ago I purchased a used A-100 system (Roughly a BS1 with an
extra G3 frame and a few extra modules). Great synth, but one VCO responds
slightly less than the other to changes on voltage on the CV1 input. My best
guess is that this can be fixed by adjusting one of the trim-pots on the
PCB, but when I pull the module out of the rack I notice several different
trim-pots, some of which I can't find names for. I notice, however, that
there are two named Range and Scale and I figure that (one of) these must be
what I need to adjust to get a more uniform response.

Am I right about this, and does anybody know which pot does exactly what

Kind regards,

Silas F. Johansen


[Non-text portions of this message have been removed]